Description
Manual Rollsizer suitable for most pistol calibres as well as 223 and 308. The manual rollsizer is a compact rollsizer suitable for processing cases in small batches around 400-500 in one sitting (typically 30-40 minutes). The manual rollsizer should be mounted to your reloading bench for the best results using G clamps or Self Tapping screws through the supplied mounting base.
A high powered drill will easily produce 2,000 cases per hour. Most drills are not designed for continuous operation so if you want to run for 1 hour, expect to replace it every few months.
The manual rollsizer uses the same rolling parts as the DC unit but requires manual cranking. The crank effort required is minimal. The rollsizer can be connected to your Dillon (TM) case feeder using the supplied hose and adaptor clip or connected to other case feeder types with some modifications. No, you cannot modify the manual rollsizer to a DC drive at a later stage. the gearbox internals are different.
The rollsizer is supplied with hex drive bits to connect your portable drill to the rollsizer. Simply remove the crank handle and insert the hex bit into your drill and the bolt fitted into the end of the crank handle shaft and run it.
That’s it, too easy.
Rollsizer kit includes all the fittings to connect to your Dillon casefeeder. The rollsizer should be mounted to your work bench for best operation. One Calibre conversion disc included and drop tubes must be ordered separately.
Machine only dimensions: 270mm x 250mm x 230mm
Reviews
There are no reviews yet.